HP Z400: no inbound remote access or internet while outbound connections work
What happened
The workstation could not be reached from outside with remote-access tools, and the browser had no internet access. However, a session started from the station itself towards an external PC connected normally, so outbound traffic was clearly passing.
What was checked
- Ping the relevant IP addresses to see which parts of the path respond.
- Check the default gateway entry and the subnet mask / address range configured on the workstation.
- The browser was also checked (an outdated version was reported in the case) but it turned out not to be the cause.
- Review the network router configuration for rules affecting the station's address.
Cause
As reported in the case, the engineers found that IP address isolation was enabled on the network router: the station's segment was blocked from inbound connections and internet access, while connections initiated by the station itself could still pass.
What was done
The engineers corrected the router configuration to remove the address isolation and allow the station's traffic out and back in. No hardware was replaced — it was purely a network settings change, and afterwards remote access and browsing worked normally.
Safety
Address isolation on a router is often a deliberate protection, so relax such rules only with approval from whoever is responsible for the site's network; and if you open the workstation case, unplug the power cord first.
Lesson: When outbound connections work but inbound ones and internet do not, check the network equipment's rules before blaming the computer.
Covered in the course: DICOM, PACS and Networks — Level 2: Fault-Finding →
Written from an anonymised case shared by service engineers. It is not a manufacturer instruction and grants no authorisation. Independent note; names are trademarks of their owners.