Early access · courses are being reviewed by field engineers
Service EngineerAcademy
Academy / Field fault notes / Sun Sun Blade
Sun · Sun Blade

Sun Sun Blade: workstation fails to boot

What happened

The workstation would not boot; no error codes were reported in the case.

What was checked

Cause

The battery in the timekeeper module had discharged, so the module lost its stored data and the boot process could not complete.

What was done

The engineers replaced the battery. Restoring the boot data afterwards was a procedure from the manufacturer's service documentation, done by authorised personnel. As reported in the case, the workstation started normally after that.

Safety

Isolate the workstation from the mains and observe ESD precautions before opening it, and confirm electrical safety before returning it to use.

Lesson: A dead timekeeper battery alone can stop a workstation from booting, but replacement is only half the fix — the stored boot data must be restored afterwards.

Covered in the course: DICOM, PACS and Networks — Level 2: Fault-Finding →

Written from an anonymised case shared by service engineers. It is not a manufacturer instruction and grants no authorisation. Independent note; names are trademarks of their owners.

← All notes